全自動瀝青抽提儀是檢測儀器，可對集料進行初步篩分.以評定路面施工時商品瀝青的質量，也適用于舊路調查時檢測瀝青及瀝青混合料的瀝青用量。

The fully automatic asphalt extraction instrument is a testing instrument that can perform preliminary screening of aggregates. It can be used to evaluate the quality of commercial asphalt during pavement construction. It is also suitable for detecting asphalt and asphalt mixture asphalt consumption during surveys of old roads.

全自動瀝青抽提儀特點：

本方法規定用回流式抽提儀法測定混合料中瀝青含量的試驗方法。

本方法適用于瀝青路面施工的瀝青用量檢測使用，以評定施工質量，也適用于舊路調查中檢測瀝青路面的瀝青用量。但對煤瀝青路面，需有煤瀝青的游離碳含量的原始測定數據。

Features of Automatic Asphalt Extractor:

This method specifies the test method for determining the asphalt content in the mixture by the reflux extractor method.

This method is suitable for detecting the amount of bitumen used in asphalt pavement construction to assess the quality of construction, and it is also suitable for detecting the amount of bitumen used in bituminous pavement in the survey of old roads. However, for coal asphalt pavement, the original measurement data of the free carbon content of coal asphalt is required.

全自動瀝青抽提儀適用范圍：

本方法規定用回流式抽提儀法測定混合料中瀝青含量的試驗方法。

本方法適用于瀝青路面施工的瀝青用量檢測使用，以評定施工質量，也適用于舊路調查中檢測瀝青路面的瀝青用量。但對煤瀝青路面，需有煤瀝青的游離碳含量的原始測定數據。

Scope of automatic asphalt extraction instrument:

This method specifies the test method for determining the asphalt content in the mixture by the reflux extractor method.

This method is suitable for detecting the amount of bitumen used in asphalt pavement construction to assess the quality of construction, and it is also suitable for detecting the amount of bitumen used in bituminous pavement in the survey of old roads. However, for coal asphalt pavement, the original measurement data of the free carbon content of coal asphalt is required.

全自動瀝青抽提儀技術參數:

★試樣容量 1000g～3000g

★抽提精度 約0.1%

★抽提時間 20～40分鐘/次

★離心軸轉速 6000rpm

★整機功率 4KW

★電源 三相4線380V 50Hz

★凈重 386kg

★主機外形尺寸1190×990×1660mm

★環境溫度： ≤35℃

★相對濕度：≤85%

Technical parameters of fully automatic asphalt extractor:

★ Sample capacity 1000g ～ 3000g

★ Extraction accuracy: about 0.1%

★ Extraction time 20 ～ 40 minutes / time

Centrifugal shaft speed 6000rpm

★ Overall power 4KW

★ Power supply Three-phase 4-wire 380V 50Hz

★ Net weight 386kg

★ Outline dimension of main machine 1190 × 990 × 1660mm

★ Ambient temperature: ≤35 ℃

★ Relative humidity: ≤85%

全自動瀝青抽提儀操作規程：

★儀器的安裝與連接

瀝青含量快速抽提儀必需置于有頂面防護的房間或棚子中，距離墻面100cm。儀器底座放置好后，應該校正水平，然后才能放置蒸發冷凝箱，連接控制儀和冷卻水管，在確認出380V及零線供電正常的情況下，黑色線為零線將儀器接通電源。

★使用前的檢查

儀器在長途運輸和長時間不用，再度使用前首行必要的檢查和運轉，確保安全A，以防發生意外。

⒈從溶劑孔注入三氯乙烯溶劑（約二十公斤）

⒉檢查儀器工作是否正常：接通電源，啟動工作開關，再按沖振及抽提鍵，使控制部分將進入工作狀態。

⒊檢查離心杯運轉是否正常，按抽提鍵，此時離心機處于轉速運轉，觀察其轉向，正常狀態下離心機按逆時針方向旋轉〔與電機旋轉方向（箭頭方向）一致〕。

⒋檢查噴淋蓋內噴頭是否堵塞。

★試驗準備

⒈取下篩網，按孔徑依次從小到大自下而上放好，將稱量過的瀝青混合料試樣放入最上層的篩中。

⒉將整套篩網放在振動架的漏斗上，蓋上噴淋蓋，旋緊螺栓。

⒊將稱量好的離心杯壓入離心筒內，蓋上離心蓋，放正振動器支架，旋緊手柄，將導流管插入離心蓋的中孔內。

四油石比的計算

瀝青混合料中礦料的總質量由兩部分組成。

mα=m1+m2

式中：mα－瀝青混合料中礦料的總質量（g）

m1－篩網中倒出的集料烘干后的質量（g）

m2－離心杯濾紙試驗前后的增量（g）

瀝青混合料中瀝青質量為瀝青混合料總質量與礦料總質量之差。

mb=m－mα

式中：mb－瀝青混合料中瀝青質量（g）

m－瀝青混料總質量（g）

mα－瀝青混合料中礦料總質量（g）

瀝青混合料的油石比，可由下式求得：

pα=m－mα/mα×**

式中： pα－瀝青混合料的石油比（%）

Full-automatic asphalt extraction instrument operating procedures:

★ Installation and connection of the instrument

The asphalt content rapid extraction instrument must be placed in a room or shed with a top surface protection, 100 cm from the wall surface. After the base of the instrument is placed, the level should be corrected, and then the evaporative condensation box can be placed. Connect the controller and the cooling water pipe. After confirming that 380V and the neutral line power supply are normal, the black line is the neutral line to connect the instrument to the power supply.

★ Check before use

The instrument is transported for long distances and is not used for a long time. Before it is used again, the necessary inspection and operation are performed to ensure safety A to prevent accidents.

注入 Inject trichloroethylene solvent (about 20 kg) from the solvent hole

⒉ Check whether the instrument works normally: Connect the power supply, start the work switch, and then press the shock and extraction keys, so that the control part will enter the working state.

⒊ Check whether the centrifugal cup is operating normally, press the extraction button, the centrifuge is running at A speed, and observe its rotation. Under normal conditions, the centrifuge rotates counterclockwise [in line with the direction of rotation of the motor (arrow direction)].

Zh

⒋ Check whether the spray head inside the spray cover is blocked.

★ Test preparation

⒈Remove the sieve, place it from bottom to top according to the pore size, and place the weighed asphalt mixture sample into the top sieve.

⒉ Put the whole set of screen on the funnel of the vibration frame, cover the spray cover and tighten the bolts.

壓 Press the weighed centrifugal cup into the centrifugal cylinder, cover the centrifugal cover, place the vibrator support, tighten the handle, and insert the guide tube into the middle hole of the centrifugal cover.

Calculation of the four oil-stone ratio

The total mass of the mineral in the asphalt mixture consists of two parts.

mα = m1 + m2

In the formula: mα-total mass of the mineral in the asphalt mixture (g)

m1-mass of dried aggregates poured out of the screen (g)

m2－Increment before and after centrifugal cup filter paper test (g)

The asphalt quality in the asphalt mixture is the difference between the total mass of the asphalt mixture and the total mass of the minerals.

mb = m－mα

In the formula: mb-asphalt quality in asphalt mixture (g)

m－Total mass of asphalt mixture (g)

mα－Total mass of the asphalt mixture (g)

The oil-stone ratio of the asphalt mixture can be obtained by the following formula:

pα = m－mα / mα × **

In the formula: petroleum ratio of pα-asphalt mixture (%)

全自動瀝青抽提儀使用注意事項：

★當全自動瀝青含量快速抽提儀在抽提的過程中，因停電而中斷抽提時，不能帶載2次啟動，否則會因離心杯中的礦粉，瀝青和三氯乙烯混合液引起中偏移，損壞離心筒，因此抽提停電，必需清理試樣及離心杯，按新的試驗重新開始。

★長途運輸時，要特別注意防震，儀器設備要分別裝入專用包裝箱，箱內墊以塑料泡沫或軟紙，四周填充密實，勿使之松動搖晃，裝卸車時小心輕放，不能碰撞，以確保儀器外表美觀，功能完好。

★儀器兩天以上不使用，要將蒸發箱的瀝青，三氯乙烯混合液和溶劑箱的三氯乙烯放出，分別存放在專用密封塑料筒內，以防對儀器腐蝕。

★離心筒，離心機頂蓋兩個部位的密封圈，每使用一次涂一次凡士林油。

★由于安裝使用不當，或儀器設備發生故障，會使試驗無法正常進行。如果儀器嚴重?fù)p壞必須交有關人員檢修。

Precautions for using the automatic asphalt extractor

★ When the automatic bitumen content rapid extraction instrument is in the process of extraction, when the extraction is interrupted due to a power outage, it cannot be started 2 times with a load, otherwise it will be caused by the mineral powder, asphalt and trichloroethylene mixed solution in the centrifuge cup. The middle offset will damage the centrifuge tube, so the extraction power failure, the sample and the centrifuge cup must be cleaned and restarted according to the new test.

★ During long-distance transportation, special attention should be paid to anti-vibration. The instruments and equipment should be packed in special packaging boxes. The inside of the boxes should be filled with plastic foam or soft paper. To ensure the appearance of the instrument is beautiful and the function is intact.

★ If the instrument is not used for more than two days, the asphalt in the evaporation tank, the trichloroethylene mixed solution and the trichloroethylene in the solvent tank are released and stored in a special sealed plastic cylinder to prevent corrosion of the instrument.

★ The seal ring of the two parts of the centrifuge tube and the top cover of the centrifuge is coated with petroleum jelly once every time.

★ Due to improper installation or use of equipment, or failure of the equipment, the test cannot be performed normally. If the instrument is severely damaged, it must be submitted to the relevant personnel for repair.